GNY 1463 Electrical
GNY 1463 Electrical
Design To:
Provide aircraft with 400Hz electrical service used to power the aircraft on the ramp. Shown with receptacles.
Other applications include fuel hydrant, fuel isolation, combination fuel high point vent/low point drain, water service, air start, preconditioned air, surge suppressor and sump. In addition the Model 1463FM pit can be used for maintenance and vault access.
Pit Shell:
The Model 1463FM pit shell is a one piece molded GRP unit composed of 30% high quality glass fiber and 70% polyester resin. The shell wall is nominally one-quarter (0.25) inches (6.4 mm) thick. The inside dimensions of the shell are 23.5 inches (600 mm) diameter by 38 inches (965 mm) deep. The shell interior is coated with a resin-rich gel coat having a white pigment to provide a bright clean environment and appearance.
Pit Cover:
The Model 1463FM pit cover is a two piece, non-skid, non-sparking assembly consisting of one stationary outer ring and an inner access cover. The inner cover can be opened a full 180 degrees with a 25lb (11.4 Kg) single hand lift on a non-weight bearing hinge. When open an 18 inch (460 mm) diameter opening is exposed. Each cover is manufactured from a high strength aluminum-zinc alloy. Covers conform to Federal Specification QQ-A-601F alloy 712.0 (formerly 40E).
Load Testing and Quality Assurance:
Each cover is guaranteed to withstand a dual 200,000 lb (90720 Kg) load applied over 200 square inches (1290 cm²) tire footprint areas placed anywhere on the cover (1000 psi (70.3 Kg/cm²) rating). This represents a 4:1 safety factor. All covers are proof load tested and evaluated in accordance with the United States Military Standard MIL-STD-105 “Sampling Procedures and Tables for Inspection Attributes”.
Available Depths:
18, 30, 52, 60 and 72 inches (460, 760,1320, 1525 and 1830 mm). Other depths are available on special order.
Options:
Flanged steel support frame for cover integrally bonded to the fiberglass shell.
Three-eighths (0.75) inch (9.5 mm) thick shell available on special order.
Liquid tight penetrations (electrical conduit, piping, etc.) through shell walls and base are available.
Split top shell to enable continuous concrete apron panel pour.
A solid, liquid tight, flat base is available.
Inner cover seal comprised of a fuel resistant “O” ring installed in a machined groove.
Available with Waterproof feature.
Available with double hinge feature.
